Following on from winning Product of the Year at the CIBSE awards in 2016, the CIBSE Journal featured a piece about EndoTherm in both print and online. Below is the article in full:

When the heating additive EndoTherm won the CIBSE product of the year award in 2016, many wondered whether it was too good to be true. The claim was that when used in a wet heating system it could improve performance by up to 15%. Despite EndoTherm mirroring these performance claims in independent testing before its 2014 launch, many regarded it as snake oil.

EndoTherm works by reducing the surface tension of water by 60%. A liquid with a reduced surface tension has a lower contact angle and improves the thermal contact area (sometimes known as the wetted perimeter) on the inside of system materials.

Wet heating systems dosed with 1% of EndoTherm will experience an improvement in system efficiency of 5-8%. This can be up to 15% in systems using condensing or modulating boilers. Not all systems will save the same amount because of the many differing variables between buildings and their heating systems.

Endo overcame suspicion by allowing customers to pay only if the product made savings. Over the last four years, EndoTherm has been installed in more than 10,000 buildings, across 15 countries. It now has more than 200 commercial case studies supporting its claims. Here are some of them:

 

Energy Saving Trust

EndoTherm was tested under the Energy Saving Trust’s (EST) product verification scheme for emerging technologies. A protocol was designed to confirm that EndoTherm can replicate its laboratory performance in live environments and the product was tested independently by consultants Atega at Fanhuelog Sheltered Accommodation Scheme, in South Wales, operated by Trivallis Housing Association.

Remote monitoring was installed at sites with a similar occupancy. Thirty-second readings were taken for internal temperature, external temperature, system flow/return temperatures and gas consumption over a 12-month period.

All sites were powerflushed and control sites were redosed without EndoTherm and compared with sites where EndoTherm had been installed. Over a six-month period, sites with EndoTherm saved 21.34% on average. The control sites, after only being power flushed, saved 7.35%. The subsequent savings of systems with EndoTherm was 13.99%

EndoTherm is the first technology of its kind to be recognised by the Energy Saving Trust as a heating additive.

 

Sainsbury’s

Sainsbury’s became aware of EndoTherm following the CIBSE award win. After initial technical discussions, Sainsbury’s decided to trial EndoTherm in its biomass fleet because the boilers have considerable quantities of instrumentation to measure accurately any efficiency gains. It is worth noting that non-modulating biomass systems will not be affected by reduced cycle times, so the expected saving in these systems is 5-8%.

Trials were done initially on four stores using a seven-day before and after comparison to ensure similar trading and climatic patterns. These averaged a 5% improvement in fuel use with a range of 2-14%. It was also noticeable that flue temperature reduced, with systems featuring the largest reductions in flue temperature also having the greatest efficiency improvements. The assessed payback was slightly more than 12 months.

Subsequently, Sainsbury’s has rolled out EndoTherm to all its biomass boilers and monitored performance through February and March. The result seen in the original four-store trial has been replicated in the roll-out, with a 5% improvement in fuel efficiency (73-78%) with a similar range across boilers. Performance was assessed between 2016 and 2017.

 

Innovation Gateway – 2Degrees

(Royal Bank of Scotland/Heathrow Airport)EndoTherm joined the Innovation Gateway in October 2015 as part of the Bristol Go Green Challenge. EndoTherm was subsequently trialled in three bank branches in the Bristol area over a 12-month period.

As part of the trial protocol, each branch was powerflushed during the installation. No other changes were made. Monthly gas meter readings were compared with the same time period in the previous year. The average improvement was 29.25%, saving a total of £1,500 and more than 10 tonnes of CO2.

EndoThermwas then trialled by another Innovation Gateway member, Heathrow Airport. The trial took place at the airport’s engineering compound using methodologies set out by the International Performance, Measurement and Verification Protocol (IPMVP).

The two-month trial, comparing use immediately before and after installation, identified a saving of 20.1%. This is a saving of £955 or 7.4 tonnes of CO2.

Before/After EndoTherm graph (Heathrow)

 

What next?

EndoTherm is continuing to engage with national bodies to validate findings and build confidence around the technology.

This year also saw the launch of EndoCool for chilled water systems, which has achieved excellent early trial results. We will continue to develop this new product sector.

The article above is available in print in the November 2017 issue of the CIBSE journal, it is also featured on the CIBSE Journal website in full, click here to read it.

 

Contact Us.

Contact Us

8 + 10 =